HEADLINE
8
USAGE
8
How to Stop
1. To stop, release the throttle
(B)
and apply the brakes, by squeezing the brake levers
(D)
, until the product comes to
a
complete stop
. When coming to a complete stop, place both feet on the ground to balance the Rambler 20.
2. Make sure to turn the product
OFF
after your ride is complete. Pressing the power button
(A)
for two seconds
will turn the product
OFF
completely.
Note:
When the brakes are applied the tail/brake light will flash. The brake light is always functional and
independent of the other lights being activated.
WARNING:
The brake is
capable of skidding the rear tire
and throwing an unsuspecting rider.
Practice in an open area free from
obstacles until you are familiar with
the brake function. Avoid skidding to
a stop as this can cause you to lose
control and/or damage the rear tire.
Note:
As an additional safety
feature, the scooter is designed to
cut power to the motor when the
hand brakes are applied.
Note:
Practice riding only in wide
open areas clear from curbs,
parking blocks and other obstacles.
Impacting the wheels against
any hard surface can damage the
wheels. Wheels are not covered
under the limited warranty.
B
D
D
A
3
Press the bottom area of the
display (as shown) to decrease power
levels in increments of one (1). Each
time you press the bottom area of
the display you will move to the next
lower power level until you reach the
lowest power level (0)/neutral.
Changing the Power Level - Pedal Assist Mode
Power levels are controlled on the display. The display is activated when the power on the Rambler 20 is in the
ON
position. Practice in an open area free from obstacles until you are familiar with changing power levels. Riders can
toggle power levels up or down while the Rambler 20 is in motion. Higher power levels can result in higher speeds and
lower power levels will result in lower speeds. There are five (5) power levels. The Rambler 20 is set on power level 0
(neutral) setting at the factory.
1
Each bar at the top of the display
represents a power level. When all
the bars are off, Rambler 20 is at
power level 0 (neutral).
2
Press the top area of the display
(as shown) to increase power levels
in increments of one (1). Each time
you press the top area of the display
you will move to the next higher
power level until you reach the
maximum power level (5).
Note: Once the electric scooter is powered OFF, power levels are disabled. Power level will reset to
level 0 (neutral) each time you power ON your electric scooter.
Note:
Power level speeds can
be affected by uphill climbs and rider
weight.
Содержание rambler 20
Страница 15: ......
