Make sure you have received all the following items
with your cabinet.
10/4/2010 (9:18 AM)
2034 - 2 - Setup v4.05
□
Mask Making Kit (if purchased with the
cabinet).
□
50 lb 150 grit Aluminum Oxide
□
HD Blast Hose (K) with 3/32” Nozzle and
holder.
□
Abrasive Recovery Bucket (2 gallon plastic
bucket)
□
Foot Pedal Assembly (F) with hoses.
□
Dust Mask
□
Blasting Gloves (18 mil)
□
Safety Goggles
□
Safety Manual
□
Setup Manual
□
Operation Manual
□
Maintenance Manual
2.5
Removal from Pallet.
! WARNING
Removal of the cabinet from the pallet requires
at least two people.
2.5.1
The cabinet is bolted to the 4x4 blocks
mounted on the pallet. Locate the bolts and remove
with ¾ inch opened end or socket wrench.
2.5.1.1
With two people slide the cabinet off from
one side so two of the casters will touch the
ground at the same time.
2.5.1.2
Once the first two casters are touching the
ground carefully slide the remaining part of the
pallet out from under the cabinet.
2.6
Footswitch Valve and Blast Hose
Setup
2.6.1
Locate the Foot Switch Valve (E) and blast
hose (K) assembly in box at bottom of cabinet.
2.6.2
On some shipments it is required to attach pipe
union nut (J) to fitting at the bottom of the pressure
pot. Use wrench to tighten.
2.7
Foot Petal Connection
The foot petal (F) has a short hose and a long hose
with quick disconnect fittings. Connect the short
hose to quick disconnect fitting on footswitch valve
(E). Connect the long hose to the quick disconnect
fitting located between water separator (G) and the
air inlet valve (C).
2.8
Dust Bag Installation
