Raytheon SC18EC, Руководство по эксплуатации

Страница: 16 / 46

Operation
2–4
F232096
CardMate Plus™ Setup
For machines equipped with the CardMate
Plus™ smart card system, perform the
following procedure to prepare the card reader
for use in a new installation.
1. Turn on the main power source (circuit
breaker or cut-off switch on the wall).
2. Insert the setup card into the card reader.
3. When the card reader displays “REMOVE
CARD,” remove the setup card from the
card reader.
4. Program the Electronic Control
parameters to match the values in the setup
card, such as:
•
Vend price
•
Coin value
See the Programming Guide for additional
information.
Start-Up
Turn on the main power source (circuit breaker
or cut-off switch on the wall). The display
shows the currently selected cycle and the
vend price for the current cycle.
Opening Door
Press the round button on the door handle and
turn the door handle downward.
Loading
Load the machine to full capacity whenever
possible, but do not exceed the rated dry-
weight capacity of the machine if the fabric to
be washed is quite dense, closely woven, and
heavily soiled. Overloading can result in an
inferior wash. The operator may need to
experiment to determine load size based on
fabric content, soil content, and level of
cleanliness required.
Partial loads are a waste of energy, water, and
chemicals, and cause greater machine wear
than full loads. Partial loads also increase the
possibility of a severe out-of-balance
condition.
When loading is complete, ensure that all
fabric is inside the basket. Then close and
lock the door by rotating the door handle
counterclockwise until the door handle
pushbutton pops out. The machine should
not start or run unless the door is both closed
and locked.
Be careful around the open door,
particularly when loading from a level
below the door. Impact with door edges
can cause personal injury.
SW025
CAUTION