54
g
WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
Disconnect electric power to the washer before servicing.
Never start the washer with any guards/panels removed.
Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
37989
40. MOTOR DOES NOT RUN
POSSIBLE CAUSE
TO CORRECT
Electrical power off, fuse blown, or power cord not
Check laundry room for blown or loose fuse(s) or
plugged in.
open circuit breakers. (Washer itself does not have
an electrical fuse).
Loading door not closed or inoperative switch.
Close door or test switch and replace if inoperative.
Timer improperly set.
Reset timer, or try another cycle.
Inoperative timer.
Test timer and replace if inoperative.
Motor starting functions inoperative. No start;
Check motor and replace if inoperative.
or motor hums only.
Motor is dead, will not run.
Check motor and replace if inoperative.
Motor overload protector has cycled.
Wait two or three minutes for overload protector to
reset. If protector cycles repeatedly, refer to
paragraph 43.
Bind in upper or lower motor bearing.
Remove belt and determine if motor shaft will spin.
Replace motor if shaft is locked up.
Broken, loose, or incorrect wiring.
Refer to appropriate wiring diagram.
Power cord is miswired.
Refer to appropriate wiring diagram for correct
wiring.
41. NO AGITATION
POSSIBLE CAUSE
TO CORRECT
Inoperative timer.
Test timer and replace if inoperative.
Inoperative action switch.
Test switch and replace if inoperative.
Motor will not run.
Check motor and replace if inoperative.
Inoperative pressure switch.
Test switch and replace if inoperative.
Broken, loose, or incorrect wiring.
Refer to appropriate wiring diagram.
Broken drive belt.
Replace belt.
Inoperative transmission assembly.
Replace transmission assembly.
Sheared motor pulley roll pin.
Remove drive motor, and replace roll pin and any
other damaged parts.
Drive motor overload protector has cycled.
Refer to paragraph 43.
Bind in pump.
Replace pump.
Loading door is open or door switch is inoperative.
Close loading door or test switch and replace if
operative.