RESET:
Settings Re-set : Pressing and holding the RESET BUTTON on the remote control
or using the manual buttons to complete a RESET will restore the factory
settings to the illuminator. Note : It will not remove a PIN if one is present.
Full Re-set : Re-cycling the power whilst pressing both manual buttons will
restore factory settings and remove a PIN if one is present.
Both indicator LEDs flash amber for both above re-sets when complete.
VARIO2 Quick Troubleshoot:
Ensure all tests are undertaken by a qualified, trained engineer. Ensure safe
working practices are followed at all times.
•
Check polarity of illuminator connection red=+ve, black=-ve
•
Ensure power is 12-24V AC or DC (For Vario 16 variants : 24V only AC or DC )
•
Ensure telemetry wires are shorted out or valid telemetry input (zero volt or
TTL) is applied and correctly wired
•
Check photocell is working. Cover photocell fully, light should turn on if valid
telemetry input. It is sometimes difficult to see Infra-Red illuminators working in high
brightness conditions.
•
Ensure power supply is suitably rated to product - check page 1 for
specifications
•
If longer cables used, ensure sufficient voltage is provided to allow for drops
across the cable
For in-depth Troubleshoot, see Full Instructions, or contact Raytec.
FFu
ullll IIn
nsstta
alllla
attiio
on
n G
Gu
uiid
de
e
Contents :
Page 2
Box Contents and Safety Information
Page 3
Short Guide and Factory Defaults
Page 6
LED Status Indicators – Feedback System
Page 8
VARIO Remote Controller (VRC)
Page 10
PIN Function Detail
Page 12
Manual Control Buttons
Page 17
Disabling Manual Buttons
Page 18
Power Up Functionality ; Re-Set Options
Page 19
Standard Bracketry
Page 20
Specifications Table
Page 21
Troubleshooting
VV
ee
rr..
11
00//
117
9
UK / Europe
Tel: +44 (0) 1670 520055
[email protected]
Americas
Tel: +1 613 270 9990
Toll Free: +1 888 505 8335
[email protected]
www.rayteccctv.com
