Raytec VARIO2 Extreme, Руководство пользователя

Страница: 15 / 33

6
LED Status Indicators- Feedback system :
There are two tri-coloured LEDs visible on the base of the VARIO2
Extreme illuminator. The two LEDs provide important operating and
status information.
The LED Indicators also give feedback if you are using the Remote, PIN
Function or Manual Control Modes
– Please see Pages 10 to 17 for detail
on the LED status indicator feedback for these functions
Programming Mode and Operating Mode
On powering up the illuminator, it automatically enters
programming mode to allow the user to adjust set-up and
operation. The programming mode automatically times out after
7 Days or until the user actively disables the remote control or the
unit times out 30 minutes after any press of the manual buttons on
the illuminator.
During Programming Mode and Operating Mode the two LED’s
indicate the following status :
LHS SOLID GREEN:
Power Applied
LHS FLASHING GREEN: Remote control IR receiver problem (Max
VRC distance is 8m (26ft)
RHS FLASHING AMBER: Indicates unit is in programming mode
(Programming Mode Only)
RHS SOLID AMBER: Indicates that a valid command is being
received from the remote (Programming
Mode Only)
LHS FLASHING RED: Voltage supply problem detected
LHS SOLID RED: Illuminator fault detected
LHS FLASHING GREEN High or low temperature ATC
(1 sec on 1 sec off) active