Raytec PULSESTAR VTR4, Руководство по установке

Страница: 30 / 38

26
10.4 General commands
Report the version of firmware running in the VTR4
This command returns the firmware version. For example:
VR returns
VTR4 (HW001) V001
Set switched mode
The output is set to switched mode at a percentage of full
brightness.
RW1,s
Where:
s = setting in percent (s = 0 to 100)
Set pulse mode
The output can be set up to pulse on a trigger input. The delay from trigger to
the start of the pulse, the length of the pulse and the brightness are
configurable.
An error is generated if the brightness setting requires a current greater
than 20A or if the combination of pulse width and setting is not allowed.
RTc,p,d,s
RTc,p,d,s,r
Where:
c = 1 to select light strobe output
c = 2 to select a trigger output signal
p = pulse width in milliseconds (0.01 to 3)
d = delay from trigger to pulse in milliseconds (0.01 to 999)
s = setting in percent (s = 0 to 100)
r = retrigger delay in milliseconds. This parameter is optional.