Raysharp D6004, Руководство пользователя

Страница: 12 / 30

User Manual
9
Note:
For 4-ch DVR, there are 4CH inputs of the sensor
For 9-ch DVR, there are 8CH inputs of the sensor
5.10
Motion Detector Setup
This section allows you to set up motion detection options for each camera.
5.11
Hard Drive Setup
This section will display the current hard drive status and usage options
HDD SIZE:
Indicates the total capacity of the hard drive installed in the DVR.
HDD USED:
Indicates the space used in the hard disk drive for recording and the percent used.
HDD FORMAT:
Will erase all video and data on the installed hard drive and make it readable
Motion Detector Setup:
ON/OFF:
Enable or disable motion detection
recording.
LEVEL:
Sensitivity for motion detection. There are 3
levels sensitivity: Level 1-low, level 2- highe, level 3-
highest
AREA: Select detectable area on the screen.
Area Selection:
Press [ ▲ , ▼ , ◄◄ or ►► ] button to select a
block, and press [
SEL
] button to set the block to detect
motion. The area is detectable when it is clear; the area is
not detectable when it is covert by shadow.
Press “Stop” button to disable all areas, press
“Quad” or “All” button to enable all areas.
Overwrite Enabled:
ON:
Overwrite oldest video when hard drive is full.
OFF:
Stop recording when hard drive is full.
HARD DRIVE SETUP
OVERWRITE ENABLED [ ON ]
ST3160215A
MASTER HDD SIZE 160133MB
MASTER HDD USED 124931MB 78%
MASTER HDD FORMAT
SLAVE HDD SIZE N/A
SLAVE HDD USED N/A
SLAVE HDD FORMAT
( )MOVE (SEL)SELECT (MENU)EXIT
MOTION DETECTOR SETUP
CH1 ON LEVEL1 AREA
CH2 ON LEVEL2 AREA
CH3 ON LEVEL2 AREA
CH4 ON LEVEL2 AREA
( )MOVE (SEL)SELECT (MENU)EXIT