RAYN Installation Guide
Lamp Head and LED Driver
Install the Lyda Lamp Head
The Lyda lamp head can be mounted by suspension or by a mounting bracket in a
horizontal (X) or vertical (Y) orientation using the end caps as the attachment points
(mounting hardware not provided).
Each end of the lamp head must be secured. Lamp heads may be linked together at
the ends, end cap to end cap, and may share the same suspension chain (or suitable
alternative) at that point.
The lamp head can be installed projecting downward, horizontally sideways for
interlighting applications, or built-in to a shelving system with suitable clearance. See
.
Note:
The installation hardware and installation location must support four
times the weight of the Lyda lamp head, lamp cable, and any installed
accessories. The lamp head must be installed within 3 m (10 ft) of the LED
driver.
1. Each end cap is provided with three mounting holes (10 mm [3/8 in] Ø) for
directional suspension. Attach mounting hardware (not provided) to the
suspension points (each end cap must be supported). You can interlock (link) end
caps together, sharing a suspension point between two linked end caps, creating
linear arrays of the lamp heads.
2. If the LED driver has been previously installed, connect the lamp cable from the
driver to the Lyda lamp head. The connection is secured by rotating the locking
ring counterclockwise until finger tight.
CAUTION:
Do not make or break connection under load.
ATTENTION :
Ne pas brancher ou débrancher sous charge.
Lamp Head and LED Driver
Page 6 of 8
RAYN
