Raymarine P70, Инструкция по установке и эксплуатации

Страница: 30 / 122

5.1 Mounting
The product is designed to be flush mounted.
Before mounting the unit, ensure that you have:
• Selected a suitable location.
• Identified the cable connections and route that the
cable will take.
• Detached the front bezel.
p70 Mounting
D12104-1
p70r Mounting
D12105-1
1. Check the selected location for the unit. A clear,
flat area with suitable clearance behind the panel,
is required.
2. Fix the appropriate cutting template supplied
with the product, to the selected location, using
masking or self-adhesive tape.
3. Using a suitable hole saw, make a pilot holes in
each corner of the cut-out area.
4. Using a suitable saw, cut along the inside edge
of the cut-out line.
5. Ensure that the unit fits into the removed area
and then file around the cut edge until smooth.
6. Drill four holes as indicated on the template to
accept the securing screws.
7. Peel the backing off of the gasket, and place the
adhesive side of the gasket onto the display unit
and press firmly onto the flange.
8. Connect cables to the unit.
9. Slide the unit into place and secure using screws
provided.
Note: Drill, tap size, and tightening torque is
dependent on the thickness and type of material
the unit is to be mounted on.
Front bezel
Removing the front bezel
D12032-2
1 2
3 4
Important: Use care when removing the bezel.
Do not use any tools to lever the bezel, doing so
may cause damage.
1. Using your fingers pull the bezel away from the
unit at the top and side, as shown in 2.
The bezel will start to come away from the unit at
the top and side.
2. Now pull the bezel away from the unit on the
opposite side, as shown in 3.
The bezel will now come free from the unit, as
shown in 4.
30
p70 / p70R