MK II Wheel Drive
13
ing the standard orientation, you can install the bracket so the pin is at the top (above the mounting
holes).
5. Making sure the slot is central at the bottom of the drive unit (6 o’clock position) and the
pin is in the
middle
of the slot, carefully draw around the bracket.
6. Remove the wheel, then hold the bracket on the pedestal in the location you have
marked.
7. Check the position and alignment of the pedestal bracket:
• the bracket pin should be 154 mm (6.1 in) below the pedestal spindle (see the follow-
ing diagram)
• the bracket pin should be aligned so it is directly below the pedestal spindle (see the
following diagram)
Standard
(also for retro-fit)
Alternative
D8901-1
D8902-1
87063_1.book Page 13 Monday, December 19, 2005 3:22 PM
