Raymarine i50 Depth, Инструкция по установке и эксплуатации

Страница: 35 / 90

6.3 Power
Powering on the unit
With power to the unit turned on but the unit switched
off:
1. Press and hold the
Power button until the unit
powers on and data is displayed (approximately
2 seconds).
Note: When power to the unit is turned on the unit
will switch on automatically.
Powering off the unit
1. Press and hold the Power button until the power
count down timer is displayed and reaches zero
(approximately 6 to 8 seconds).
6.4 Data master
Where a system contains more than one unit
capable of displaying a data type, the unit physically
connected to the transducer must be set as the data
master and any other units set as a repeater.
Checking i50 Depth software version and
status
1 0
15
20
25
30
35
40
45
50
55
60 5
4 +
D12451-2
D e pth A la rm
D e pth
During normal operation:
1. Press and hold the
Depth and Alarm buttons at
the same time for approximately 4 seconds, until
the Software Version page is displayed.
2. Press the Depth button to display the Instrument
Status page.
Master (transducer connected) or Repeater (No
transducer connected).
3. To change the status:
i. Press the Offset and Reset buttons at the
same time.
The status will flash.
ii. Press either the Offset or Reset to change
the status between Master or Repeater.
i. Press the Offset and Reset buttons at the
same time to confirm the status.
4. To exit the Intermediate calibration settings at
any time, press and hold the Depth and Alarm
buttons at the same time for approximately 4
seconds to return to normal operation.
i50 Depth
35