Raymarine i50 Depth, Инструкция по установке и эксплуатации

Страница: 21 / 90

3.6 Selecting a display location
Warning: Potential ignition source
This product is NOT approved for use in
hazardous/flammable atmospheres. Do
NOT install in a hazardous/flammable
atmosphere (such as in an engine room
or near fuel tanks).
General location requirements
When selecting a location for the unit it is important
to consider a number of factors.
Ventilation requirements
To provide adequate airflow:
• Ensure that equipment is mounted in a
compartment of suitable size.
• Ensure that ventilation holes are not obstructed.
• Ensure adequate separation of equipment.
Mounting surface requirements
Ensure units are adequately supported on a secure
surface. Do NOT mount units or cut holes in places
which may damage the structure of the vessel.
Cable routing requirements
Ensure the unit is mounted in a location which allows
proper routing and connection of cables:
• Minimum cable bend radius of 100 mm (3.94 in) is
required unless otherwise stated.
• Use cable supports to prevent stress on
connectors.
Electrical interference
Select a location that is far enough away from
devices that may cause interference, such as
motors, generators and radio transmitters/receivers.
Magnetic compass
When choosing a suitable location you should aim
to maintain the maximum possible distance between
the unit and any compasses.
To prevent potential interference with the vessel's
magnetic compasses, ensure that a minimum
distance of 230 mm (9 in) between the unit and any
installed compasses is maintained.
Viewing angle considerations
As display contrast, color and night mode
performance are all affected by the viewing angle,
Raymarine recommends you temporarily power up
the display when planning the installation, to enable
you to best judge which location gives the optimum
viewing angle.
Viewing angle
D xxxxx-1
7 0° 7 0°
7 0°
7 0°
Planning the installation
21