Raymarine E70058, Инструкция по установке и эксплуатации, Страница: 21 / 68

i50 Speed connection
D12390-1
4
5
1
2
3
Item Cable color Signal name
1 Brown Temperature 0 V
2 White Temperature (signal)
3 Screen Speed 0 V (shield)
4 Green Speed (signal)
5 Red Speed V+
i50 Tridata connection
7
8
4
5
6
D12393-1
2
1
3
Item Cable color Signal name
1 Black (Depth) Piezoceramic –
2 Blue (Depth) Piezoc
3 Screen (Depth) 0 V (shield)
4 Brown (Speed) Temperature 0 V
5 White (Speed) Temperature (signal)
6 Screen (Speed) Speed 0 V (shield)
7 Green (Speed) Speed (signal)
8
Red (Speed) Speed V+
Making transducer connections
Although the transducer cable is fitted with spade connectors for
direct connection to the rear of the unit, it may be necessary to
remove these to facilitate installation, e.g. if the cable has to be
routed through narrow apertures. 1/8th spade terminals will be
required (not supplied), to replace those removed. When fitting the
new spade connectors, prepare the cables as detailed below:
3 mm
6 mm 50 mm
1
2
D12359-1
1. Prepare the cable as shown in 1 above.
2. Fold back the wire strands and insert into the new spade
connector as shown in 2 above.
3. Ensure the wire strands do not extend beyond the rear of the
spade connector insulation.
4. Crimp the connector to the wire.
iTC-5 connection
Transducers can be connected to a SeaTalk ng network using
Raymarine's Instrument transducer converter (iTC-5) and an i70
instrument, the data can then be repeated on an i50 / i60 unit.
12 V
D12033-3
1 2 3 4
5
6 7 8
1 i50 Depth (Repeater)
2 i70 Instrument (Master)
3 i50 Speed (Repeater)
4 i60 Wind (Repeater)
5 iTC-5
6 Depth transducer
7 Wind vane transducer
8
Speed transducer
Note: Transducers connected to the iTC-5 must be calibrated
using an i70 (master) unit. Transducers connected to the iTC-5
cannot be calibrated using an i50 / i60.
Making iTC-5 transducer connections
For instructions on connecting transducers to your iTC-5 refer to
the iTC-5 handbook.
Cables and connections 21