RAYLASE IPG, Руководство по оборудованию

Страница: 12 / 13

Chapter 3 Programming
12 RAYLASE IPG Interface Board MN027 / v1.1.0
3.3 Programming sequence
Initialisation:
Init_Scan_Card (); // Initialise Scan Card
Load_Cor (lpstrFileName); // Load Correction File
Set_Mode (0x0420); // Set YAG1-mode (Bit 5 = 1, Bit
4 = 0)
Setting Master Oscillator input of IPG Laser with Control Commands:
Set_Start_List_1(); // Filling Job Data into List 1
Set_Delays_7_8 (t1, t2); // Set Laser Modulation Signal
Set_Delays_9_10 (t3, t4); // t4 = 0
Write_Port_List (0x0A, value); // Set Laser Power
... // List Commands for Marking
Set_End_Of_List();
...
// Start Marking
Write_Port (0x0C, 0x0010); // Switch-On Master Oscillator of
IPG Laser
... // Wait 10msec
Execute_List_1(); // Execute Job
...
Write_Port (0x0C, 0x0000);
// Switch-Off Master Oscillator
of IPG Laser
Setting Master Oscillator input of IPG Laser with List Commands:
Set_Start_List_1(); // Filling Job Data into List 1
Write_Port_List (0x0C, 0x0010); // Switch-On Master Oscillator of
IPG Laser
Long_Delay 1000(); // Wait 10msec
Set_Delays_7_8 (t1, t2); // Set Laser Modulation Signal
Set_Delays_9_10 (t3, t4); // t4 = 0
Write_Port_List (0x0A, value); // Set Laser Power
... // List Commands for Marking
Write_Port_List (0x0C, 0x0); // Switch-Off Master Oscillator
of IPG Laser
Set_End_Of_List();
...
Execute_List_1();
// Execute Job
Checking Laser Alarms and Resetting of IPG Laser:
Read_Port (0x08); // Read Bit 6 of Port A for
checking of Laser Alarm
// If Bit 6 set to FALSE then an
error occured
...
Write_Port (0x0C, 0x0020); // Set Signal Remote_Execute_1 to
TRUE
... // Wait 1ms
Write_Port (0x0C, 0x0); // Set Signal Remote_Execute_1 to
FALSE