RAYLASE IPG, Руководство по оборудованию

Страница: 11 / 13

Programming Chapter 3
MN027 / v1.1.0 RAYLASE IPG Interface Board 11
3 PROGRAMMING
The following sections describe how to program an IPG laser for use with RAYLASE control
card and RAYLASE IPG interface board.
3.1 Signals
Use the following signals to program the IPG interface board:
Signals of control card Description
/LM Setting Input Pulse Repetition Rate of IPG Laser
/MIP Switching On/Off the Master Oscillator Input of IPG Laser
/FPS Setting Power Setting Latch Input of IPG Laser
/PB 0-7 Setting 8 Bit Power Inputs of IPG Laser
/LM_Gate Switching On/Off the Laser Modulation Input of IPG Laser
/Remote_Execute 1 Reset IPG Laser after Detection of Alarm Condition
/PA 6 Reading of combined Alarm1 to Alarm3 outputs of IPG Laser
3.2 Commands
To program the IPG interface board use the following commands:

Set_Delays_7_8, Set_Delays_9_10

Write_Port_List

Long_Delay

Read_Port

Write_Port

YAG1-Mode is required, Bit 4 = 0, Bit 5 = 1
See also the manual „Commands and Functions“ for details.