Raychem 920 Series, Инструкция по установке и эксплуатации

Страница: 17 / 20

nVent.com | 17
4.3.5 “COMMON SETUP...” Sub-Menu
The “Common Setup” sub-menu is used to configure parameters that are common to both
control Points A and B. These settings are set up only once to define the operation of both
control points.
CONTROL SETPOINT = 20°C
LO TS 1 = -10°C
LO LOAD = 1.0 A
HI GFI = 50 mA
GFI TRIP = 75 mA
TS ALARMS CONFIG...
OTHER ALARMS CONFIG...
POINT SETUP...
COMMON SETUP...
COMMUNICATIONS SETUP...
--- END ---
Common Setup Sub-Menu
TEMP UNITS = {°C or °F}
VERSION = V3.14.0
EXT. INPUT = {NOT USED, TEMPBUS, INHIBIT or
FORCE ON}
EXT. OUTPUT = {NOT USED, TEMPBUS or INHIBIT}
FLASH ALARM
OUTPUT
= {YES or NO}
ALARM OUTPUT = {N.C. or N.O.}
LANGUAGE = {ENGLISH or FRANCAIS}
POINT B USED = {YES or NO}
PASSCODE = {0000 to 9999} (only if 0 or database is
unlocked)
SCROLL DELAY = {0.07 to 0.25} S
COPY CONFIG... Note the “...” indicating a
sub-menu.
--- END ---
Table 4.8
4.3.5.1 “COPY CONFIG...” Sub-Menu
The “Copy Config” sub-menu is used to copy configuration parameters.
COPY CONFIGURATION Sub-Menu
DEFAULTS TO COMMON (copies the Factory default COMMON
parameters to memory)
DEFAULTS TO A (copies the Factory default Point parameters to
control Point A)
DEFAULTS TO B (copies the Factory default Point parameters to
control Point B)
A TO B (copies Point A settings to Point B)
B TO A (copies Point B settings to Point A)
--- END ---
Table 4.9