![Raycer RAY24CBT Скачать руководство пользователя страница 13](http://html1.mh-extra.com/html/raycer/ray24cbt/ray24cbt_instruction-manual_3882545013.webp)
13
CUTTING WITH A NYLON HEAD
TRIMMING:
This is feeding the trimmer carefully into the material you
wish to cut. Tilt the head slowly to direct debris away from you.
If cutting up to a barrier such as fence, wall or tree, approach
from an angle where any debris ricocheting off the barrier will
fly away from you, Move the line head slowly until the grass is
cut right up the barrier, but do not jam (overfeed) the line into
the barrier. If trimming up to a wire mesh or chain linked fence
be careful to feed only up to wire. If you go to far the line will
snap off around the wire. Trimming can be done to cut through
weed stems one at a time. Place the trimmer line head near the
bottom of the weed-never high up which could cause the weed
to chatter and catch the line. Rather than cut the weed right
through, just use the very end of the line to wear through the
stem slowly.
WARNING DANGER
Do not to use a steel blade for edging or scalping.
SCALPING AND ENGING:
Both of these are done with the line head tilted at a steep angle
Scalping is removing top growth leaving the earth bear.
Edging is trimming the grass back where it has spread
over a sidewalk or drive way. During both edging and
scalping, hold the unit a steep angle and in a position
where the debris, and any dislodging dirt and stones,
will not come back towards you even if it ricochets off
the hard surface. Although the picture shows how to
edge and scalp every operator must find for himself the
angles which suits his body size and cutting situation.
WARNING DANGER
Do not trim in any area where there are strands of
fencing wire. Wear protective safety protecting , Do not
cut where you cannot see what the cutting device is
cutting.