12
CUTTING WITH A NYLON HEAD
For nearly all cutting, it is good to tilt
the line head
so that contact is made on the part of the
circle where the line is moving A W A Y
you and the debris shield. See appropriate)
This results in the debris being thrown A
WAY from you.
Line head rotates in a CLOCK WISE
direction. The CUT-OFF KNIFE will
be on the right side of the debris shield.
WARNING DANGER
Tilting the head to the wrong side will shoot
the debris TOWARDS you. If the line head is
held flat to the ground so that cutting occurs
on the whole line circle, debris will be
THROWN at you, drag will slow the engine
down, and you will use up a lot of line.
WARNING DANGER
Use only quality nylon monofilament line of
the diameter 2 mm. Never use wire or
wore-reinforced line in place of nylon
trimmer line. Load your nylon line cutting
head only with nylon trimmer
WARNING DANGER
Use extreme caution when operating over
bare spots and gravel, because the line can
throw small rock particles at high speeds.
Debris shields on the unit cannot stop objects
which bounce or ricochet off hard surfaces.
WARNIN DANCER
The proper debris shield must be in place
on the unit when nylon cutting line is used,
The cutting line can flap around if too
much line is exposed. Always use the
plastic debris shield with cut-off knife
when using nylon cutting heads.
