Fast and Furious Arcade
10 |
P a g e
Cabinet Assembly
CAUTION
UNDER NO CIRCUMSTANCES SHOULD THIS GAME BE OPERATED UNLESS ALL INSTALLATION PROCEDURES
HAVE BEEN COMPLETED AND ALL SAFETY FEATURES HAVE BEEN POSITIVELY TESTED AND ARE FULLY
FUNCTIONAL!
*****It is recommended that the main cabinet be moved to or very near its desired operational location
before beginning any of the setup tasks (see pg. 46 (Single Game) or pg. 48 (Twin Games) for footprint
measurements).*****
Lower Monitor Installation
1.
Remove the upper and lower back doors from the cabinet.
2.
Unpack monitor and use packaging to stand monitor in an upright position on the floor.
3.
Insert the (4) spacers (
fig.
a DETAIL A below) included with the monitor mounting kit into the (4)
mounting holes on the back of the monitor. ***These spacers must be used to maintain a proper air
space and keep the monitor from overheating.***
4.
Set monitor up onto cabinet ledge, line up with mounting slots in cabinet and hold monitor to face of
cabinet as shown (
fig. a
below).
5.
Use (4) 8Mx65MM screws (
fig.
a DETAIL A below), with (1) washer on each screw to secure monitor.
Do not tighten screws until final setup is completed, minor adjustments may be required if setting up
multiple linked games.
6.
Plug AC cord into AC socket and install the HDMI-DVI cable into HDMI 1 at rear of monitor and the
DVI port on the graphics card at rear of PC.
7.
Set the upper/lower monitor cross bracket on top of the cabinet with channel capturing the top of
the lower monitor and secure using (4) #8 wood screws (
fig. a
below).
fig. a
