Ravenheat CS 80 T, Инструкция по использованию, установке и обслуживанию

Страница: 51 / 67

Fig.53
Fig.55
Fig.54
51
8.23 TO REMOVE PANEL CONTROL BOX
(Fig. 51,52,53).
Remove the front panel (fig. 39). front panel (fig. 39).
Pull forward the control panel box with Pull forward the control panel box with
both hands until it is slightly out of the
both hands until it is slightly out of the
boiler. As doing so move the box
boiler. As doing so move the box over to
the left while still pulling it forward until
the control box becomes free.
Lift and fix the box on the depression
chamber with the service retaining clips
(fig. 53).
This will allow free access to lower part
of the boiler.
Fig.51
Fig.52
8.24 TO REMOVE THE INSTRUMENT PANEL
(Fig. 54).
Remove the front panel (fig. 39). front panel (fig. 39).
Push the four retaining latches and Push the four retaining latches and
remove the front of the panel box (fig.
remove the front of the panel box (fig.
54).
54).
8.25 TO REMOVE/REPLACE CONTROL 8.25 TO REMOVE/REPLACE CONTROL
BOARD (Fig.55).
BOARD (Fig.55).
Remove the front panel (fig. 39). Remove the front panel (fig. 39).
Remove the instrument panel (sect. Remove the instrument panel (sect.
8.24).
8.24).
Detach all connectors from control board,
Detach all connectors from control board,
unscrew the four screws and lift up.
unscrew the four screws and lift up.
Replace in reverse order (fig. 55).
Replace in reverse order (fig. 55).
8.26 TO REMOVE/REPLACE DIGITAL 8.26 TO REMOVE/REPLACE DIGITAL
DISPLAY BOARD.
DISPLAY BOARD.
Remove the front panel (fig. 39). Remove the front panel (fig. 39).
Remove the instrument panel (8.24). Remove the instrument panel (8.24).
Detach the connectors and unscrew the
Detach the connectors and unscrew the
four screws.
four screws.
Replace in reverse order.
Replace in reverse order.
8.27 EXTERNAL CONTROL CONNECTION 8.27 EXTERNAL CONTROL CONNECTION
(Fig. 54)
(Fig. 54)
Remove the front panel (fig. 39). Remove the front panel (fig. 39).
Remove the external wire link on the Remove the external wire link on the
panel control box.
panel control box.
Replace with external wire controls.
Replace with external wire controls.
(These must be volt free). (These must be volt free).