Raven SmartYield Pro, Руководство по установке

Страница: 37 / 43

Chapter 6
30 SmartYield™ Pro Installation Manual
Bracket Mounting
Refer to the following procedure to mount the SmartYield Pro control node using the node mounting kit (P/N
117-0171-299).
1.
Insert a 1/4” bolt (P/N 311-0049-103) through the recessed side of the ceramic magnet
assembly (P/N 418-0000-013). The threaded side of the bolt should extend past the flat side of the magnet
assembly.
2.
Insert the bolt through the pre-drilled holes in the mounting bracket (P/N 107-0171-897).
FIGURE 1.
SmartYield Pro Node Mounting Plate
Note:
If the magnet sticks to the bracket, it will not hold the bracket to a metal surface on the combine.
Flip the magnet over before proceeding.
3.
Secure the magnet to the bracket using a 1/4” nut (P/N 312-4000-057). Repeat this process to secure the
remaining magnets to the node plate.
4.
Insert a 3/8” bolt (P/N 311-0054-105) through the magnet side of the mounting plate.
5.
Thread the bolt through the SmartYield Pro control node (P/N 063-9000-002) mounting tab and fasten the
node to the mounting plate using a 3/8” nut (P/N 312-4000-061).
6.
Repeat this process to secure the two remaining node tabs to the mounting plate.
7.
Mount the node and bracket assembly to the machine on the elevator side (right hand side) of the harvester.
Mount in a location free from moving parts, excessive vibration, and heat sources.
Important:
Arrow three must be pointing towards the ground with arrow two, four, five, or six pointed forward.
Magnet Mounting Posts
Node Mounting Posts
or or