Raven SmartYield Pro, Руководство по установке

Страница: 17 / 43

016-0171-566 Rev. C 13
Yield Sensor Installation
FIGURE 3.
Angled Paddle Mounting Brackets
Refer to the SmartYield Pro Calibration and Operation Manual for details on the calibration and to
help determine if tabs are necessary for your specific harvester. See the Yield Sensor Paddle
Extension Plates section on page 18 for details on installation of the paddle extension plates.
Yield Sensor Locations
Review the following table for the offset measurement
required for each specific harvester make and model. The
offset value (X) is measured from the wall on the lift side of
the clean grain elevator.
TABLE 1.
Harvester Make and Model Offset
Measurements
Make Model
‘X’ Measurement
Inches Millimeters
Case IH
1460 1-3/8 35
1660, 2166 1-9/16 40
1680 2-3/8 60
2188/2388
2-3/8 inside
1-15/16 outside
60 inside
50 outside
Claas
Dominator 86, 96, 98 1-9/16 40
Dominator 106, 108, 118, 204, 218, Lexion,
Tucano
1-3/4 45
Dominator 112 CS, Comm 116 CS, 228 2-3/8 60
Avero 240 1-3/16 30
CNH CS, CSX 2-3/16 55
Duetz Fahr
4080 1-3/8 35
8XL 2-3/8 60
5690 HTS, 6095 HTS 2-9/16 65
Fiat L517 2-3/8 60
Fortschritt
E514, E517 1-3/4 45
E524 1-9/16 40
Angled Paddle
Mounting Bracket
Optional Extension
Plate
Sensor
Beam
Sensor Offset ‘X’
Measurement