Raven SmartYield Pro, Руководство по установке

Страница: 33 / 43

Chapter 5
28 SmartYield™ Pro Installation Manual
Connecting an Aftermarket Rotary Switch
An aftermarket rotary switch kit (P/N 117-9000-007) is available if a factory rotary sensor is not installed from
the manufacturer or is not compatible with the available Raven header sensor cables.
FIGURE 3.
Aftermarket Rotary Switch (D/N 054-9000-007)
Note:
Contact a local Raven dealer for additional information on the optional rotary switch.
Tips on Mounting Aftermarket Rotary Switch
•
The sensor should be mounted to the chassis or another stationary part of the combine. The end of the
linkage rod should be mounted to the feeder house to the linkage arms move when the header moves.
•
Two lengths (50mm or 110mm) of threaded rod are provided. Use the rod that provides the best range of
motion that is free from obstructions.
•
Depending on the machine configuration, it may be necessary to move the magnet to the alternate
mounting hole on the sensor bracket.
•
Depending on machine configuration, it may be necessary to mount the feeder house magnet directly to the
swivel arm instead of using the 90° bracket.
•
The sensor shaft can rotate a continuous 360° degrees, and the output signal varies between 0.5V and
4.5V.
Important:
The signal changes abruptly from 0.5V to 5.4V (or vice versa) when the flat face of the shaft is closest to
the sensor’s connection. Mount the sensor and linkage arms so that the operating range of the header
does not cause the sensor shaft to cross the threshold. Refer to Figure 4.
Alternate Mounting Holes to
Adjust Linkage Arms
Alternate
Magnet
Mounting Hole
Magnet
Mounted to Chassis (Stationary)
Magnet Mounted to Feeder
House so the Linkage
Arms Move when the
Header Moves
50mm or 110mm Threaded Rod