Raven SmarTrax MD, Руководство по установке

Страница: 28 / 36

Chapter 4
24 John Deere 8X60 and 8X70 Series SmarTrax™ MD Installation Manual
4.
Connect the node harness to the operator presence switch, if applicable.
a.
Locate and disconnect the machine’s existing OPERATOR PRESENCE connection behind the
operator’s seat, if applicable.
b.
Connect the round 4-pin connector from the node harness to the machine’s mating OPERATOR
PRESENCE connector.
FIGURE 6.
Mechanical Drive Connection
5.
Connect the 8-pin Deutsch connector from the node harness into the 8-pin port of the mechanical drive
(P/N 063-4001-010).
6.
Ensure the terminator (P/N 063-0172-369) supplied with the node harness is securely installed on the
remaining 4-pin Deutsch connector.
Install the Chassis Cable - SmarTrax MD-
Only Systems (If Applicable)
If the machine does not contain an existing chassis power system (such as AutoBoom, product control, etc.), it
is necessary to install the chassis power cable to operate the SmarTrax MD system. If a CAN system already
exists on the machine, refer to below to connect power to the SmarTrax MD system.
Note:
The chassis cable is sold separately. Contact your local Raven dealer or ordering information.
1.
Locate the SmarTrax chassis cable (P/N 115-4001-085).
2.
Connect the TO SMARTRAX NODE connector from the chassis cable to the round 16-pin connector on the
node harness (P/N 115-4001-157).
3.
Connect the TO CONSOLE CABLE connector to the Raven console cable.
4.
Install a terminator (P/N 063-0172-369) on the CAN cable connector.
5.
Loop and tie-off the REMOTE SWITCH cable connection, securing it with plastic cable ties as necessary.
Note:
The REMOTE SWITCH connector is not used in the SmarTrax MD system. Ensure the cable is
secured away from moving parts and heat sources.
6.
Connect the ring terminals to the battery.
Note:
The positive connectors are fused.