Raven SmarTrax MD, Руководство по установке

Страница: 20 / 36

Chapter 3
16 John Deere 8X60 and 8X70 Series SmarTrax™ MD Installation Manual
FIGURE 14.
Washer and Nut Installed
3.
Install the washer and nut on the protruding male spline adapter.
FIGURE 15.
Distance Measurement
4.
Measure the distance from the top of the telescope stem to the top of the steering wheel hub to verify the
distance is close to the measurement taken when the steering wheel was removed.
Note:
If the distance is not close to the first measurement:
1. Remove the spline nut, washer, and assembly bolts.
2. Remove the male spline adapter.
3. Loosen the set screws used to secure the installed telescope adapter.
4. Adjust the placement of the telescope adapter on the machine’s telescope rod, relative to the
distance between the two measurements.
5. Tighten the set screws and reinstall the male adapter and assembly bolts.
6. Reinstall the spline washer and nut.
Measure
Distance