CALIBRATE SC1 | CRX + SC1 AUTOSTEERING | RAVEN EUROPE GENERIC
PAGE 16/37 | Calibration manual | 016-8000-015EN | Rev. A1
Raven Industries Inc.
After a few seconds, the instructions change
from not touching to ‘turn the steering
wheel at a typical rate’.
When this instruction shows, turn the
steering wheel at a normal speed from left to
right and back again. Do not stop steering
until the next step pops up
After the steering, the next screen appears.
Stop steering. The Disenage Pressure is now
set at a calibrated value. When the
disengage status is green, the system is able
to autosteer.
When steering the steering wheel, the
disengage status should move to red. This
means in practice, the autosteer shuts off
when turning the steering wheel at this
typical rate. It is possible to change the
calibrated value by pressing on the value
and enter another value.
Select the ‘
Next
’
arrow.
36
The next step is to calibrate the Wheel Angle
Sensor Value. This can only be performed
when driving between 1.6 – 6.4 km/h.
Make sure the speed is between those limits
and turn the steering wheel to the left.