Raven Command FLEX II, Руководство по калибровке и эксплуатации

Страница: 72 / 144

CHAPTER 8
62 RCM - Sprayer and AIM Command FLEX™ II Calibration and Operation Manual
Speed Source. Displays any detected speed sources and options to select. “Auto” is recommended for most
applications.
Switch Box. Displays detected section control switch status information.
Section Status. Displays section driver status information.
Working Parameters. Displays the implement width, current speed, speed source, speed source ISO name, and
address.
Pressure Sensors. Displays voltages and pressure information for each pressure sensor.
Task Totals. Displays the area covered and volume applied for the current task.
Inertial Sensors. Displays the detected ECU yaw rate and downward direction.
TESTS
Run diagnostic tests to check system operation, for help locating components requiring service or replacement,
and other information to assist with keeping the AIM Command FLEX™ II working at maximum efficiency.
To access available tests:
1. Open the UT Menu and select the RCM - Sprayer Menu button.
2. Select the Diagnostics softkey.
3. Select the Tests Tab at the top of the page. The following diagnostic tests are available:
NCV Communication Test. Scans the NCV CANbus communication and assists in locating where issues may be
present. Boom graphics show indexing order from leftmost to rightmost NCVs. No Communication After and
Communication Resumes At values will be shown. When only a few NCVs are noted, inspect nearby NCVs,
connections, pins, and cabling for corrosion, visible damage, or pinching between those NCVs. In some
instances, splices or wiring may be damaged underneath cable sheathing. Inspect those items along with fuses,
19-pin connections, and terminators when large sections of NCVs are not communicating.
NOTE: Refer to Chapter 9, Troubleshooting , for additional assistance with NCV
Controller Statistics. This process allows you to view detailed product controller performance and health statistics
including Boom Pressure, Target Pressure, Pump Control Effort, Actual Flow per Area, and Target Flow per area
over a user-defined amount of time. You may start the test immediately or press delayed start to start the test
later. The test will record up to two parameters, and provide a graph of performance.
NCV Statistics. Allows access to view NCV statistics including Driver Temperature, Logic Temperature, Open Hold
Current, Powered Time, and HC Voltage Minimum. Press Start Data Visualization to generate an on-screen
graph of each NCV. Arrow over to see data for a specific NCV.
NCV Updates. Scans all NCVs for potential updates. If an update is detected, an option will be given to update the
software. This test requires the engine to be running and the NCV bus to be communicating and properly
terminated.
Calibrate NCVS. This test will allow you to recalibrate your NCVs. This process is recommended after replacing
one or more NCVs.
RCM - Sprayer Menu Diagnostics
UT Menu
Tests