Raven Command FLEX II, Руководство по калибровке и эксплуатации

Страница: 23 / 144

System Calibration: Initial Start Up and Calibration Wizard 13
SYSTEM CALIBRATION
SYSTEMS WITH SIDEKICK PRO ICD INJECTION PUMPS
1. Locate the Sidekick Pro ICD ECU serial number. The serial number is typically located on the front or top of the
direct injection pump.
2. Assign the desired Sidekick Pro ICD ECU to the desired product channel ECU number.
NOTE: The RCM-Sprayer ECU is factory configured as ECU number 1 and cannot be changed.
FIGURE 2. Injection Wizard Serial Number Assignment
3. Press the Next softkey.
TIP SETUP, AND TIP SIZE
When setting up an RCM - Sprayer system without AIM Command FLEX™ II NCVs, or if the Skip NCV Setup option
is selected:
1. Enter the “Bypass Tip Spacing” and “Bypass Tip Size.”
NOTE: If no spray tips are installed, or if the installed tip size is not available in the drop down menu, select
NA as the tip size.
When setting up a AIM Command FLEX™ II NCV control system:
1. Verify that the actual number of AIM Command FLEX™ II NCVs on the system matches the value shown in the
Total NCVs field detected by the ECU.
2. Verify the actual number of NCVs connected to the left boom (center of the boom to the tip of the left boom)
circuit matches the value shown in the Left NCV Count field detected by the ECU.
NOTE: Touch the Redetect NCVs button to allow the system to detect NCVs connected to the nozzle bus.
If the total number of NCVs, or the left NCV count, displayed does not match the actual number of
nozzle control valves connected to the system, touch the Redetect NCVs button to allow the system
to redetect NCVs connected to the nozzle bus. Refer to Chapter 9, Troubleshooting , for assistance
with the AIM Command FLEX™ II nozzle control valve circuit.
To bypass nozzle control valve configuration and operate the system without the AIM Command
FLEX™ II NCVs, press the Skip NCV Setup button. If Nozzle Control Valves are installed on the
machine, the NCVs will remain closed and must be manually bypassed at the boom by opening a
secondary flow outlet or removed from the machine to apply product. The system will then operate
as a conventional sprayer with the RCM - Sprayer ECU.