Items Needed:
• Live digital phone line
• Female RJ11 wall plate
• Screwdriver
610POOLD, 646POOLD
610POOLD
646POOLD
Page 6
Installation:
1. On the back of the unit, plug the line cord into the female RJ11 wall plate.
2. Phone should slide onto wall plate and clip itself into place.
3. Phone is preset to dial 911. If required to call an alternate number not given to RATH® at time of purchase, please
follow programming instructions on page 7. If phone is calling 911, unit is ready for testing.
Note:
To open unit up for programming, use a small flat head screwdriver to gently lift the plastic covering window
on the front of the unit. Lift the logo after plastic is removed. Use a screwdriver to remove the 2 screws. Once
screws are loosened, gently lift up and out the red plastic housing on the underside of the phone. The red housing
should come off completely exposing the keypad.
Programming
Most Pool Phones are already pre-programmed to call 911. Only perform the following if you want the phone to
call somewhere other than 911.
Speaker Phones
Please choose one of the options below that matches the type of line that the phone is installed on:
1. Standard Telephone Line Programming
a. Press
ENTER
to begin programming
b. Press
1
,
ENTER
, (phone number you want the phone to dial),
STOP
c. Press and hold
STOP
for 3 seconds to exit programming
2. Switchboard Telephone Line Programming
(Hotel Industry)
a. Press
ENTER
to begin programming
b. Press
1
,
ENTER
, key in access code (usually 8 or 9),
PLAY/PAUSE
, (phone number you want the phone to
dial),
STOP
c. Press and hold
STOP
for 3 seconds to exit programming
3. Ring-Down Telephone Line Programming
a. Press
ENTER
to begin programming
b. Press
1, 9, ENTER, 2
c. Press and hold
STOP
for 3 seconds to exit programming
Handset Phones
Contact RATH® Technical Support at 800-451-1460 ext. 3 if you need to re-program a digital handset phone.