Installation:
1. After opening the door on the enclosure, use the provided Allen wrench to remove all 4 screws securing the
internal plate.
2. Completely remove the internal plate.
3. Using a drill bit or knockout set, drill a hole in the bottom of the enclosure large enough for the water tight
connector.
Note:
Be sure the hole sits far enough back so it doesn’t interfere with the internal plate when it’s reinstalled.
4. Using appropriate mounting screws and anchors, screw enclosure to the wall.
5. Run telephone line in conduit, bring line into the enclosure through the water tight connector, and tighten conduit
to connector.
6. Connect incoming line to the biscuit jack, then plug the line cord connected to the circuit board to the RJ11 jack on
the biscuit jack.
7. Phone is preset to dial 911. If required to call an alternate number not given to RATH® at time of purchase, please
follow programming instructions on page 7. If phone is calling 911, screw internal plate back into place. Unit is
ready for testing.
Items Needed:
• Live digital phone line
• 120vac power
• Drill
• Metal capable drill bit or knockout set
• Biscuit jack
• Mounting screws
• Wall anchors
• Conduit with (2) water tight connectors
• 3/32 Allen wrench (provided)
• Screwdriver
998RDPOOLD, 998SYPOOLD (YELLOW)
Installation:
1. After opening the door on the enclosure, use the provided Allen wrench to remove all 4 screws securing the
internal plate.
2. Completely remove the internal plate.
3. Using a drill bit or knockout set, drill a hole in the bottom of the enclosure large enough for the water tight
connector.
Note:
Be sure the hole sits far enough back so it doesn’t interfere with the internal plate when it’s reinstalled.
4. Using appropriate mounting screws and anchors, screw enclosure to the wall.
5. Run telephone line in conduit, bring line into the enclosure through the water tight connector, and tighten conduit
to connector.
6. Connect incoming line to RJ11 connector and plug into RJ11 jack on board. Or, obtain a biscuit jack, terminate
incoming line to the biscuit jack, and plug the included phone line into the RJ11 connector on the biscuit jack.
Note:
Do not cut RJ11 jack of supplied line cord and splice phone line onto it.
7. Run 120vac into the other conduit and water tight connector. Connect 120vac to the supplied transformer in the
enclosure using proper wire nuts. Red is hot, black is neutral, and green is ground (see page 8 for a more detailed
wiring diagram).
Note:
The transformer is wrapped separately in the box.
8. Locate the green battery backup pack in the enclosure. Plug the white connector located on the battery pack into
the “BATTERY” connector in the bottom left corner of the yellow board.
9. Turn on the electrical power.
10. Phone is preset to dial 911. If required to call an alternate number not given to RATH® at time of purchase,
please follow programming instructions on page 7. If phone is calling 911, screw internal plate back into place.
Unit is ready for testing.
Page 5
