Page 3
Mounting
624POOLD, 624MPOOL, 978POOLD
Items Needed:
• Live digital phone line
• Drill
• Drill bit or knockout set
• Biscuit jack (provided with 624POOLD & 624MPOOL)
• Mounting screws
• Conduit with water tight connector
• 1/8” Allen wrench (provided)
• Screwdriver
• Mounting feet (provided)
• 120vac power (978POOLD only)
• Conduit with (2) water tight connectors (978POOLD only)
Installation:
1. After opening door on unit, use the Allen wrench to remove the 4 screws securing the internal plate.
2. Completely remove the internal plate.
3. Using a drill bit or knockout set, drill a hole in the bottom of the enclosure large enough for the water tight
connector.
Note:
Be sure the hole sits far enough back so it doesn’t interfere with the internal plate when it’s reinstalled.
4. Turn enclosure over and screw 1 mounting foot onto each mounting hole on the back of the enclosure using
provided screws.
5. Using appropriate mounting screws, screw enclosure to the wall using the other side of the mounting feet.
6.
624POOLD & 624MPOOL:
Run telephone line in conduit, bring line into the enclosure through the water tight
connector, and tighten conduit to connector.
7.
624POOLD & 624MPOOL:
Connect incoming line to the biscuit jack, then plug the line cord connected to circuit
board to the RJ11 jack on the biscuit jack.
Note:
Do not cut RJ11 jack of supplied line cord and splice phone line onto it.
8.
978POOLD:
Run 120vac in the other conduit and water tight connector. Connect 120vac to the supplied
transformer in the enclosure using proper wire nuts. Red is hot, black is neutral, and green is ground (see
page 8 for a more detailed wiring diagram).
Note:
The transformer is wrapped separately in the box.
9.
978POOLD:
Locate the green battery backup pack in the enclosure. Plug the white connector located on the
battery pack into the “BATTERY” connector in the bottom left corner of the yellow board.
10.
978POOLD:
Turn on electrical power.
11. Phone is preset to dial 911. If required to call an alternate number not given to RATH® at time of purchase,
please follow programming instructions on page 7. If phone is calling 911, screw internal plate back into place.
Unit is ready for testing. The 624MPOOL is a manual dial phone and will not have a preset number.
Note:
If phone does not have a dial tone when the handset is lifted, please reverse polarity of the incoming
phone line.