Ratek SWB10D Water Bath - Operating Manual
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Page 23 of 24
Ratek
Ratek
Ratek
Ratek Service Contact Informati
Service Contact Informati
Service Contact Informati
Service Contact Information
on
on
on
Ratek are here to assist you in getting the most from your water bath. Our friendly staff can you assist you at any stage of
the product lifecycle.
If you have any concerns or questions regarding the operation of your water bath, please contact us.
Contact Us
Contact Us
Contact Us
Contact Us
Ratek
Ratek
Ratek
Ratek Instruments Pty Ltd
Instruments Pty Ltd
Instruments Pty Ltd
Instruments Pty Ltd
60 Wadhurst Dve
Boronia
Victoria 3155
Australia
Telephone : 613 9887 2161
Fax : 613 9887 2163
Email:
Web:
www.ratek.com.au
Troubleshooting
Troubleshooting
Troubleshooting
Troubleshooting
The water bath provides a simple-to-operate user interface when used in conjunction with this User Manual.
If at any stage, you are presented with an abnormal condition (anything other than the current temperature or temperature
set-point once the water bath has completed it’s startup procedure) being displayed on the LCD temperature display
(element 3 in Figure 1), this may indicate a fault condition. If the oscillating cradle fails to operate, or any other control or
indicator on the water bath fails to operate as per this User Manual, this may indicate a fault condition.
The equipment is fitted with a replaceable mains safety fuse. If the replaceable mains fuse has operated, no power will be
made available to the control systems and no controls will activate. This may indicate an electrical fault. In such cases the
replacement fuse (as specified in the technical specifications of this User Manual) should be fitted only by an authorized
service agent once they have tested and inspected the water bath. Under no circumstances should the user or operator
replace the safety fuse.
Fault conditions must be referred to an authorized service technician immediately and the equipment should be
unplugged from the mains power supply socket.
Make a written note of any displayed error codes and contact Ratek using the contact details provided in the section of
this User Manual titled “Ratek Service Contact Information” if you believe your equipment is exhibiting a fault condition.
Warranty Conditions
Warranty Conditions
Warranty Conditions
Warranty Conditions
This Ratek product is covered by a 3 year parts and 12 months labour return-to-base warranty effective from the date of
purchase. The product is manufactured in Melbourne, Australia.
The warranty is offered by Ratek Instruments Pty. Ltd. located at 60 Wadhurst Drive, Boronia, Victoria, Australia 3155,
phone 613 9887 2161.
•
This warranty covers the repair or replacement of any parts or components found to be defective, subject to the
service options listed below.
•
The warranty is a return-to-base warranty, meaning the product must be returned to Ratek Instruments or an
authorised Ratek agent for service at the discretion of Ratek Instruments. Where practical an on-site repair may
be carried out at the discretion of Ratek Instruments.
•
This warranty excludes any defect resulting from misuse, neglect, accidental damage, improper voltage,
operation of the product outside the acceptable operating conditions as indicated in these operating instructions
or any alteration which affects the performance of the equipment.
