Rasmussen Solaire, Инструкция по использованию и уходу

Страница: 11 / 28

Page 9
WARNING:
IMPORTANT - L.P. MODELS.
Before Lighting...
Inspect the gas supply piping or hose
prior to turning the gas "on". If there is
evidence of cuts, wear, or abrasion, it
must be replaced prior to use. Do not
use the Grill if the odor of gas is pre-
sent. The pressure regulator and hose
assembly supplied with the unit must
be used. Never substitute regulators
for those supplied with the grill. If a
replacement is necessary, contact the
factory for proper replacement.
Screw the regulator (Type QCC1) into
the tank. Leak check the hose and
regulator connections with a soap
and water solution before operating
the Grill.
ALL MODELS.
To Light Grill Burners:
Turn all knobs to "off" then turn on the
gas supply. Always keep your face
and body as far away from the grill
as possible when lighting.
Open the lid, depress the igniter button,
then push and turn the right hand
control knob to the "HI" position. You'll
hear a snapping sound. At the same
time a spark will be provided at the
right hand grill burner. It will be
necessary to keep the igniter button
depressed until the burner is lit.
If the burner does not light in 4 seconds,
turn knobs to "off" and wait 5 minutes
before trying again, to allow any
accumulated gas to dissipate. If the
burner will not light after several
attempts then it can be match lit.
Keep your face as far away from the
grill as possible and pass a lit, long
stem match through the grilling grid to
the burner you are trying to light. If
attempting to light the right burner first,
ensure that only the right burner control
knob is used.
Position the match near the burner
ports. Push and turn the control knob
to "HI". Repeat procedure on the
center and left burner if necessary. If
the burner does not light in 4 seconds
turn the knob off, wait 5 minutes and
try again. If the burner will not light
after several attempts see Page 13:
Troubleshooting.
Repeat the above procedure for each
grill burner.
To Light the Side Burners
(Model IRBQ-56):
Always keep your face and body as
far away from the burners as possible
when lighting.
Push and turn the Side Burner right
hand control knob to the "lite" position
and immediately depress the right
hand igniter button. You'll hear a snap-
ping sound. At the same time a spark
will be provided at the Front side burner.
It will be necessary to keep the igniter
button depressed until the burner is lit.
Repeat the operation using the Side
Burner left hand control knob for the
rear side burner.
If the burners do not light in 4 seconds,
turn knobs to "off" and wait 5 minutes
before trying again, for any accumulated
gas to dissipate. If the burner will not
light after several attempts then the
burner can be match lit.
LOW HEAT ADJUSTMENT
THE LOW HEAT SETTING ON YOUR
GRILL IS PRESET AT THE FACTORY.
ADJUST ONLY IF ALTITUDE OR ENVI-
RONMENTAL FACTORS ARE CAUSING
POOR LOW HEAT PERFORMANCE.
NEVER ADJUST THE BURNER SO
LOW THAT IT MAY GO OUT DURING
USE. DO NOT OPERATE GRILL WITH
LOW HEAT SCREW REMOVED.
1. Follow lighting instructions and
allow grill to fully preheat for 3 minutes.
2. Turn the control knob to LOW and
wait for the burner temperature to
drop and stabilize. Attempting adjust-
ment at any setting other than LOW
can create a dangerous condition.
3. Remove the knob by pulling straight
away from control panel (see Fig. 5).
4. Insert a small (3/32” dia.) blade
screwdriver into the valve stem. Turn
counter-clockwise to increase low heat,
clockwise to reduce low heat.
5. Once proper adjustment is reached,
reattach knob by pushing onto stem.
DO NOT ATTEMPT TO
LIGHT THE GRILL IF THE
ODOR OF GAS IS PRES-
ENT. CALL FOR SERVICE.
Figure 5
Remove Knob
Lighting Instructions