Rasmussen Solaire, Инструкция по использованию и уходу

Страница: 8 / 28

Leak Testing
Page 6
GENERAL
Although all gas connections on your
SOLAIRE INFRARED Grill are leak test-
ed at the factory prior to shipment, a
complete gas tightness check must be
performed at the installation site due
to possible mishandling in ship-
ment, or excessive pressure
unknowingly being applied to the unit.
Periodically check the whole system for
leaks, or immediately check if the smell
of gas is detected.
BEFORE TESTING
Make sure that all packing material is
removed from the grill including the
burner tie-down straps.
Do not smoke while leak testing.
Never leak test with an open flame.
Make a soap solution of one part liq-
uid detergent and one part water. You
will need a spray bottle, or brush to
apply the solution to the fittings. For
L.P. units, check with a full cylinder.
TO TEST
Make sure all control valves are in the
"OFF" position. Turn the gas supply
on. Check all connections from the
supply line, or L.P. cylinder up to and
including the manifold pipe assembly.
Soap bubbles will appear where a
leak is present. If a leak is present,
immediately turn off gas supply, tighten
any leaking fittings, turn gas on, and
recheck.
If you cannot stop a gas leak turn off
the gas supply and call your dealer
where you purchased your Grill. Only
those parts recommended by the
manufacturer should be used on the
Grill. Substitution can void the warranty.
Do not use the Grill until all connections
have been checked and do not leak.
IMPORTANT NOTE
ALWAYS CHECK FOR LEAKS AFTER EVERY L.P. TANK CHANGE
Check all gas supply fittings for leaks before each use. It is handy to keep a
spray bottle of soapy water near the shut-off valve of the gas supply line.
Spray all the fittings. Bubbles indicate leaks.
Disconnected L.P. cylinders must have threaded valve plugs
tightly installed, and must not be stored in a building, garage
or any other enclosed area. The gas must be turned off
at the supply cylinder when the unit is not in use.
If the appliance is stored indoors, the cylinder must be disconnected
and removed from the appliance. Cylinders must be stored outdoors
in a well-ventilated area out of the reach of children.