Chapter 3: DX Series
22
CC represents a contact closure sensor channel. There are five CC
channels: CC1 through CC5.
DC represents a dry contact signal actuator channel. There are two
DC channels: DC1 and DC2.
DX-D2C6 hall effect sensor (reserved):
DX-D2C6 contains a built-in hall effect sensor, which can detect whether
a door is open or closed. The hall effect sensor is reserved for future use
and currently shall NOT be used. After connecting DX-D2C6 to a Raritan
PDU or EMX, this built-in sensor will be detected and show up in that
PDU or EMX web interface and SNMP MIB, which is normal.
DX-D2C6 terminals, dip switches, and LEDs:
Terminals, dip switches, and LEDs are located in two rows as shown
below.
Numbers
Components
CC and DC channels.
Top row:
Four CC channels (CC2 - CC5).
Two DC channels (DC1 - DC2).
Bottom row:
One CC channel (CC1).
See
Connecting Detectors/Actuators to DX
(on page 34)
for how to connect CC sensors or DC actuators.
Dip switches for configuring the Normal state of each CC
channel. See
Adjusting Dip Switches
(on page 38).
Top row:
Dip switch 1 controls CC2.
