Raritan Dominion SX16, Инструкция по установке и эксплуатации, Страница: 52 / 162

38 D
OMINION
SX I
NSTALLATION AND
O
PERATIONS
M
ANUAL
Network
Overview
The Network configuration screen provides an area for Administrators to define both the network and modem
(optional) settings for the unit.
Figure 41 Network Configuration Display
Some Dominion SX units comes equipped with a 56Kbps (bits per second) modem, which allows dial-in access to
the unit from virtually any location in the world. On other Dominion SX units, there is a connector on the rear panel
for a user-supplied external modem. Client computers connect to the unit by establishing a PPP (Point-to-Point
Protocol) link between the client machine and the Dominion SX unit. Once the PPP connection is established, the
client computer is physically on the same network as the Dominion SX unit and can access the unit using Internet
Explorer or Netscape browsers.
There are three requirements for dialing into the unit:
1. The phone line to the unit must be connected.
2. The modem / PPP connection settings must be configured.
3. The dial-up networking software on the user’s personal computer must be configured to establish a PPP
connection from the client computer to the unit.
Configure Network Parameters
•
IP address : IP address for the unit
•
IP subnet mask : Subnet mask to be used when deployed in the network
•
IP gateway : Gateway that the unit uses to communicate with other systems that are not on the same subnet
•
Dominion SX Unit Name : Name to be associated with the unit, 64 characters in length. Valid characters are A-
Z, a-z, -, _, 0-9, no spaces or special characters allowed
•
Terminal Type : Type of terminal supported; default is VT100
•
Port Address : Port address to be used by the unit when communicating with other systems; the default port
address is 23, but can also be set to any value in the range of 2000-2400 (please verify this value with your
firewall administrator)
Click on the [
Update ] button to load all the changes.
Click on the [ Save ] button to make the changes permanent.
Important! Remember that saving changes to Network Configuration settings will cause the unit to reboot.