SAB-QS Quick Start
2 of 5
November 9, 2000
Rapid Controls Inc.
Box 8390
§
Rapid City, SD
§
57709
Phone: 605-348-7688
§
Fax: 605-341-5496
http://www.rapidcontrols.com/
§
email: [email protected]
2.
Transducer Connections (Connector JP3)
JP3 provides the connections to the transducers. Power from JP4 is passed through to the transducer on
JP4 pins 5, 7, 12, and 14. The following pins must be connected for operation of transducer channel 0:
Pin 1 is connected to the transducer CLK+/INT+ wire (yellow).
Pin 2 is connected to the transducer CLK-/INT- wire (green).
Pin 3 is connected to the transducer DATA+/GATE+ wire (pink).
Pin 4 is connected to the transducer DATA-/GATE- wire (gray).
Pin 5 is connected to the tranpower wire (red or brown).
Pin 6 is connected to the transducer ground wire (white). The shield may need to be connected,
depending on the type of transducer (see included note).
Pin 7 is connected to the transducer –power wire (blue) if needed.
The following pins must be connected for operation of transducer channel 1:
Pin 8 is connected to the transducer CLK+/INT+ wire (yellow).
Pin 9 is connected to the transducer CLK-/INT- wire (green).
Pin 10 is connected to the transducer DATA+/GATE+ wire (pink).
Pin 11 is connected to the transducer DATA-/GATE- wire (gray).
Pin 12 is connected to the tranpower wire (red or brown).
Pin 13 is connected to the transducer ground wire (white). The shield may need to be connected,
depending on the type of transducer (see included note).
Pin 14 is connected to the transducer –power wire (blue) if needed.
Note: Transducer wire colors are MTS Temposonics wire colors. Other manufacturers may use different colors.
3.
Quadrature Connections (Connector JP2)
The quadrature output from the SAB-QS is provided on connector JP2. The following connections
should be made for operation of quadrature channel 0:
Pin 1 is connected to the quadrature line A input of the controller.
Pin 2 is connected to the quadrature line /A (A not) input of the controller.
Pin 3 is connected to the quadrature line B input of the controller.
Pin 4 is connected to the quadrature line /B (B not) input of the controller.
Pin 7 is connected to logic ground.
