Ranger DST-64T, Инструкция по установке и эксплуатации

Страница: 35 / 80

DST-64T / DST642D Wheel Balancers
35
P/N 5900192 — Rev. F — March 2021
Pull out the Inner Arm and place it against the Inner Edge of the Wheel and hold it there;
wait for
the Balancer to beep .
When the Balancer beeps, return the Inner Arm to its rest position.
The Inner Window value changes to show the Distance from the edge of the Balancer to the Inner
Edge. The Width Window changes to show no value. The Outer Window changes to show the
Diameter of the Wheel.
Note
: The Inner Window always shows distance in centimeters (cm). The Distance Ruler on the
Inner Arm is graduated in centimeters and cannot be modified.
If using the DST-64T, place the tip of the Outer Arm on the Outer Edge of the Wheel and hold it
there;
wait for the Balancer to beep . When the Balancer beeps, return the Outer Arm to its
rest position.
A width value appears in the Width Window; determined by the Outer Arm.
If using the DST642D, measure the width of the Wheel using the Calipers, then use the up and
down triangle shaped buttons under Width to change the value in the Width Window.
When there are values in all three windows, the Balancer has enough information to perform a
Dynamic Balance of the Wheel.
Lower the Hood or push Start ; the Wheel spins briefly.
When the Wheel stops, look at the values that appear in the Inner and Outer Windows on the
Display Panel; these values are the correction weight values required for each plane.
The measurement system, in grams or ounces, is indicated by an LED under each window. To
switch between grams and ounces, press the
Stop
button
, then press Distance
+
at the same
time.