Ranger DST-64T, Инструкция по установке и эксплуатации

Страница: 17 / 80

DST-64T / DST642D Wheel Balancers
17
P/N 5900192 — Rev. F — March 2021
Install the four Hex Bolt, Split-Ring Lock Washers, and standard Washers to secure the Display
Panel Base Plate to the Balancer. Tighten bolts securely, but do not overtighten.
⚠
CAUTION Do not pinch the wiring between the Display Column and the Balancer Housing. This
will cause a short circuit and potentially destroy the electronics of the Balancer.
Installing the Hood
The Hood covers the Wheel while it spins during a Balancing.
⚠
CAUTION Keep away from the Hood and the Wheel while the Wheel is spinning. Touching the
Wheel while it is spinning can result in injury.
To install the Hood :
Locate the Hood, the Hood Mount Arm, and the Hex Bolt and Washers required to connect them.
–
The Hood connects to the Hood Mount Arm using two Hex Bolt and Washers.
– The Hood Mount Arm connects to the Mount Box via a Hole in one end of the Arm.
Not necessarily to scale. Not all components shown.
Starting with the
bottom
of the Hood Mount Arm
, slip the hole at the bottom over the
Shaft on the left side of the Hood Mount Box (shown in the drawing on the previous page).
Orient the Hood Mount Bar so that the Bumper goes up against the back of the Balancer.
Align the Set Screws on the bottom of the Hood Mount Arm with the Grooves in the Shaft, then
tighten the Set Screws down into the Grooves in the Shaft.
When the Set Screws are correctly installed, put the large Washer and hex head bolt into place on
the end of the Shaft (the Hex Head Bolt Hole) and tighten the hex head bolt.
Switching to the
top
of the Hood Mount Arm
, remove the two Hex Bolt and the Washers.