Ranger DST-64T, Инструкция по установке и эксплуатации

Страница: 27 / 80

DST-64T / DST642D Wheel Balancers
27
P/N 5900192 — Rev. F — March 2021
• Control buttons . Control the Balancer.
The Control buttons are:
–
OPT . Used with the Optimize Function.
– ALU . Press to switch between Dynamic Mode and ALU Mode.
– FINE . Press and hold to see exact Balance values without
rounding to the nearest 5g (.17 oz.).
– mm / inch . Toggles between millimeters (mm) and inches for
those windows that show these measurements.
To switch between grams (g) and ounces (oz) when a window
shows appropriate values, press and hold
Stop and then press
the
Distance
+
button.
–
C
. Used to initiate calibration procedures.
Important : The Balancer comes from the factory calibrated .
There is no reason to calibrate it when you first receive it. You only need to calibrate
it if you see multiple incorrect balances.
Also used with the Stop button to toggle the Auto-Hood function on-off. When toggled on,
the Wheel will automatically begin to spin when the Hood is lowered. Press Stop+C to toggle
off, press
Stop+C
again to toggle back on.
– STA button . Switches between Dynamic and Static Modes.
– D button . Performs a test of the Balancer display and software. POS will display after
successful test.
– Start button . Starts the Wheel spinning, which can also be done by lowering the Hood, if the
Auto-Hood function is toggled on.
– Stop button . Stops the Wheel from spinning. When displaying weights, holding the stop
button then pressing the Di will display units from g to oz. and oz. to g.
Also used with the C button to toggle the Auto-hood function on-off. Press Stop+C to toggle
off, press Stop+C again to toggle back on.