Ranger Products RL-8500, Инструкция по установке и эксплуатации

Страница: 21 / 54

21
STEP 8
(Making The Scratch Cut)
1. Loosen the Cutting Tip Locking Knobs and back out
both of the tips by turning the Tip Micro Dials counter clock
wise, to provide clearance for the rotor.
2. Loosen the Spindle Feed Lock.
3. Loosen the Spindle Feed Hand Wheel lock.
4. Turn the Spindle Feed Wheel and center the Twin
Cutter Head on the rotor.
5. Align the Twin Cutter. The slot of the twin cutter should
be approximately parallel to the lathe spindle and the center
of the twin cutters lined up with the center line of the rotor.
6. Secure the twin cutter to the tool holder with the self
aligning Lock Nut and washer assembly. Tighten the nut
firmly.
7. Tighten the Spindle locking Knob.
8. Tighten the Spindle Handle Wheel Locking Knob.
9. Install the Safety Shield. The Safety Shield is easily
lowered onto the Work Light. Position the Shield / Light
over the Cutting tips/ rotor. Review the cautions and
dangers section and the general safety information at the
beginning of this manual.
10. Loosen the Cross Feed Hand Wheel Lock Knob.
11. Loosen the Cross Feed Lock Knob.
12. Turn the Cross Feed Hand Wheel clockwise until the
Cutter is halfway across the face of the rotor.
13. Check all clearances closely to make sure that
nothing will “crash” when the power is turned on and the
rotor starts rotating.
NOTE:
It may help to manually turn the rotor
by hand to check all clearances.
ENSURE THAT THE TWIN CUTTING TIPS ARE
CLEAR OF THE ROTOR PRIOR TO TURNING ON
THE SPINDLE MOTOR.
MAKE SURE THE DRUM / ROTOR CROSS FEED
SWITCH IS IN THE NEUTRAL POSITION.
KEEP HANDS clear of moving parts at all times. Keep
hair, loose clothing, neckties, shop rags, jewelry, fingers,
and all parts of body away from moving parts.
Always wear safety glasses or a face shield. Cutting an
exposed surface such as a brake drum, rotor or
flywheel will produce flying chips and debris.
14. Move the Feed Selector switch to the Neutral
position.
15. Set the Speed Feed Dial to 0.