Rangemaster GEO, Инструкции по установке и информация по уходу

Страница: 16 / 32

14
Due to our policy of continual improvement, we reserve the right to change specifications without prior notice.
Replacing the filter
Once you have decided that the filter needs replacing, you
can order a replacement from the service contact details
shown on the front of the boiler. When replacing the filter,
have a dry cloth to hand for any small drips.
1.
Turn on the cold filtered water by pushing the tap
handle backwards.
2.
Turn the blue lever found on the three way tee
(E4)
to
the off position.
3.
The flow rate of the filtered water coming from the tap
should gradually decrease, before stopping completely.
4.
Turn the filter
(C5)
anticlockwise (from right to left).
5.
Pull the filter
(C5)
downwards away from the filter head
(C3)
.
6.
Unpack the new filter and check for any transport
damage, write the replacement date on the filter label
and remove the blue plastic dust cap from the top of
the filter.
7.
Insert the filter cartridge
(C5)
upwards into the filter
head
(C3)
. Note the filter label must face forward when
fitted.
8.
Turn the filter cartridge
(C5)
clockwise (left to right) to
secure the filter cartridge
(C5)
to the filter head
(C3)
.
9.
Turn the blue lever found on the three way tee
(E4)
to
the on position. Once the trapped air has cleared, cold
filtered water will come from the tap. The water might at
first be discoloured, but this is normal and will clear with
flushing.
10.
With a kitchen measuring jug and a clock you must:
A.
Flush at least the first 5 litres of water away.
B.
*Adjust the blue lever on the three way tee
(E4)
so
the flow rate of filtered water through the tap is
2 litres per minute (500 ml every 15 seconds or 1
pint every 17 seconds).
11.
Once completed, turn off the cold filtered water tap,
then check around the new filter and head for any leaks.
12.
Finally reset the filter life indicator bar by pressing and
holding both the up (  ) and down (  ) keys on the
boiler control for a few seconds. The filter indicator bar
will refresh once complete.
n #
We only warrant the original filter type supplied
with your boiler, which is formulated specifically for
the GEO or AGA 4in1 product. If the filter is removed
or exchanged for an alternate model it may have a
detrimental effect to your system and accordingly
will invalidate your warranty. If you have specific or
unusual incoming water conditions please contact
the service number on the boiler for further advice.
n
#
Failure to adjust the incoming water flow rate
may reduce the filter life or prevent the filter
from performing correctly, leading to premature
damage to other components of the system and will
therefore invalidate your warranty.
n #
The filter head must be replaced after 5 years of use.
Fig. 7.2