28
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
First fit the levelling tool on the hexagonal adjusting
nut as shown below.
Make 10 complete (360°) turns clockwise. (This means
turning and removing the levelling tool 20 times).
Make sure you lower BOTH REAR ROLLERS. There are
two adjusting nuts, one for each roller, at both the
front bottom corners of the cooker.
Unfold the rear edge of pack base tray. Carefully push
the cooker backwards into position. Take care not to
damage the power cable. Push the cooker close to its
final position, leaving just enough space to get behind
it.
Levelling
You are recommended to use a spirit level on a shelf
in one of the ovens to check for level.
Place the cooker in its intended position taking care
not to twist it within the gap between the kitchen units
as damage may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To
adjust the height of the rear of the cooker use the
levelling tool supplied to turn the adjusting nuts at the
front bottom corners of the cooker.
Adjust the height of the front roller to level the cooker.
Turn clockwise to raise the cooker and anticlockwise
to lower.
When you are satisfied with the height and level, raise
the front of the cooker by one turn of the front roller
adjuster. Screw down the front feet to meet the floor.
Screw the front roller adjuster anticlockwise to raise
the front roller so that the front of the cooker is
supported on the feet,
not
the front roller, to prevent
accidental movement of the cooker.
Leave the levelling tool in the storage drawer,
so that the customer can use it if they wish to
move the cooker.
Fitting a stability bracket
A stability bracket or chain (
not supplied by with
the cooker
) should be fitted when the cooker is
connected to a flexible gas supply.
When fitting a stability bracket read these instructions
together with the leaflet supplied with the bracket.
1.
Place the cooker in its intended position and level
the cooker.
2.
Draw a pencil line 100mm from the front edge of
the levelling feet.
3.
Mark the centre line for the bracket by measuring
550mm from the left hand side of the cooker.
4.
Lower the front roller and move the cooker
forward.
5.
Measure back from the pencil line 550mm to
locate the front edge of the bracket. Fix the bracket
to the floor.
6.
Measure the height from floor level to
engagement edge in back of cooker. Add 3mm to
this dimension and assemble the stability bracket
to this height. (i.e. from floor level to underside of
the top member) and ensure the bracket does not
foul the oven burner assembly.
