27
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
the other side. Do not box the cooker in; it must still
be possible to move the cooker in and out for cleaning
and servicing.
A minimum space of 650mm is required between the
top of the hotplate and a horizontal combustible
surface.
Any cooker hood should be installed in accordance
with the hood manufacturer’s instructions.
For safety reasons curtains must not be fitted
immediately behind the cooker.
A clearance of 130mm is required if the cooker is near
a corner of the kitchen to allow the oven doors to
open. The actual opening of the doors is slightly less
but this allows for some protection of your hand as
you open the door.
Unpacking the Cooker
Do not take any packaging off the cooker until it is
directly in front of the place it is to be installed (unless
it will not fit through a door in its outer packaging).
Cut the banding straps and lift the cardboard box off
the cooker, LEAVING THE COOKER STANDING ON
THE BASE PACKAGING. See the loose unpacking
sheet.
Moving the Cooker
The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker.
Ensure that the floor covering is firmly fixed, or
removed to prevent it being disturbed when moving
the cooker around. You will need the levelling tool.
From the back tilt the cooker forward and remove the
rear half of the polystyrene base pack.
Repeat from the front and remove the front half of the
poly base. Pull the drawer out to its furthest point.
Lift up the ends of the plastic clips (one each side) to
release the catches holding the drawer to the side
runners and at the same time pull the drawer forward
and away from the side runners. For safety’s sake
push the drawer runners back out of the way. Put the
drawer some where safe - do not refit it until the
installation is complete.
Lower the Rollers.
Fit the Allen key tool to the centre roller lowering
mechanism (C in the fig. below).
A left rear roller, B right rear roller, C centre roller
LOWER THE FRONT ROLLER by doing 14 complete
(360°) turns clockwise.
Now LOWER THE TWO REAR ROLLERS.
