RR27T
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
Page 9
39.) Remove 2 10mm Nuts & Bolts and plastic tubing for small safety cover
mount
40.) Set small safety cage in place, re-install 10mm bolts nuts and tubing
41.) Bolt roller travel mount to processor, 2 – 13mm bolts and nuts (mount
may be in Toolbox)
42.) Mount toolbox, 2 – 13mm bolts and nuts
43.) Position & tighten chainsaw actuator tab so it will activate valve when
moved, can adjust later if needed
44.) Adjust bolt on swivel plate (in black circle) so that when the sawbar is
pulled down the bolt head hits the body to stop the swivel plate, this will
allow the chainsaw to cut through the log but stops it from going further
and stretching the cable.
45.) Adjust cable so that when the chainsaw bar is pulled down, the cable
will activate the ram valve, to tight and the cable will stretch, to loose and
the ram won’t activate. The cable can be adjusted at both ends.
