RR27T
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
Page 4
7.) Lift processor off crate with forklift, crane or jacks, make sure that
straps will not catch anything on unit when tightened and that unit will be
balanced.
Lift high enough to be able to install Axle, Wheels and Tripod
8.) Remove lower crate from work area
9.) Install Tripod leg at front of processor
10.) Loosen Axle retention Bolts and lock nuts (18mm x 18mm)
11.) Slide Axle through tube, make sure the bolt holes face upwards,
centre the axle in the housing, tighten bolt, tighten lock nut, repeat on
opposite side
12.) Grease all 4 wheel bearings, use a flat screwdriver to remove dust
seals from hubs and remove inner wheel bearings for greasing
13.) Install Wheel on axle
