RR27T
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
Page 5
14.) Install Bearing, then washer
15.) Screw on Castle Nut make sure to line threads up
16.) Tighten castle nut until nut is snug and wheel is hard to turn, then
back the nut off ¼ turn until cotter pin hole lines up
17.) Insert cotter pin and bend
18.) Install hub cap, use a rubber mallet to press into place
19.) Grease wheel hub generously through grease zerk on back of hub
Repeat on opposite side
20.) The four lug nuts of each wheel should be torque to 90ft-lbs.
Lower unit to floor
Assembler must check that the engine and hydraulic couplers
are secure and spaced properly
