Range Road Enterprises Ltd
Box 5 Site 9 RR1
Lacombe, AB T4L 2N1
www.range-road.ca
Lumber Position
9.
Clamp the log in place against the Log Supports using the Log Clamp Assembly in the
location.
10.
Tighten all Bolts and T-Handles on the Log Clamp Assembly and the Log Supports . Verify
that they are securely in place before proceeding.
NOTE: Make sure the Log Clamp Assembly does NOT interfere with the Saw Blade when sawing. The
Log Clamp Assembly should be lower than the Saw Blade at all times.
Scale and Scale Pointer
11.
Align the cutting Blade with the top of the log, loosen the Scale Pointer Knob and adjust the Scale Pointer
to point at a starting mark on the Scale. Tighten the Scale Pointer Knob.
12.
Release both T-Handles . Turn the Height Adjustment Handle and lower the cutting height until the Scale
Pointer points to the desired thickness. Tighten both T-Handles.
13.
The cut direction must be as shown below. If the log is cut from the other direction, the saw blade will push
the log away from the supports and may cause the log to become unstable.