Range Road Enterprises Ltd
Box 5 Site 9 RR1
Lacombe, AB T4L 2N1
www.range-road.ca
OPERATING INSTRUCTIONS
Read all of the safety using this product.
Engine Operation
Inspect engine and equipment looking for damaged, loose or missing parts before
operating. If any problems are found, do not use equipment until fixed properly.
Start Procedure
Before starting the engine:
A) Follow the Set Up Instructions to prepare the equipment. Follow all
instructions in the separate engine manual provided with the engine. B)
Inspect the equipment and engine.
C)
Fill the engine with the proper amount and type of fuel and oil.
D)
Read the Equipment Operation section that follows
1.
Start and operate the engine according to the provided engine manual.
2.
Replacement engine operating instructions can be obtained from the engine manufacturer.
Equipment Operation
1.
Wear heavy-duty work gloves, ANSI-approved goggles behind a full face shield, steel-toed work boots, and
a dust mask.
2.
Operate only with the assistance of another qualified person.
3.
Fill the Water Tank with clean water.
4.
The log must be at least 112cm (3’ 8”) long and must rest on at least two log supports to prevent instability.
5.
Cut branches off the log to be processed before sawing.
6.
Do not cut logs containing foreign objects (nails, metal, etc.). This will cause Blade damage and could cause
serious injury.
7.
Choose the Short Log Supports or the Long Log Supports according to the log diameter.
8.
Place the log to be cut on the Supports. See Figure T. Brace the log against the Log Supports to prevent
movement during sawing. The log should be positioned so that the force of cutting holds it against the
supports. Log supports need to be lower than the thickness of the board being cut to avoid blade damage.